Recent content by gjman7

@EV Sportline Are these the brush bars referenced on the aluminum front bumper page or are there other specific brush bars built to go with those? Also, will the rear bars be compatible with upcoming rear bumper?

I've got a new update and probably the last one! I received a new ultrasonic sensor. This time it was OEM with actual Rivian stamped part numbers. I tested it and it showed continuity like the other OEM ones do. Unfortunately, after installation, the system still does not work. My next step...

Well... After finishing repairs and playing musical chairs with the sensors when I still got the error, I finally broke out the multimeter. The cable harness was successfully repaired, however both eBay ultrasonic sensors I bought were duds. I compared them to two known good oem sensors. I was...

I was using a similar method but not with that much heat shrink. I have plenty of it, I'll take your suggestion on it. I was also doing it upside down through the holes in the bottom bumper panel while the applique was missing which I won't have to do anymore thanks to the instructions you...

Thank you! This is more than I could have hoped for. If there's no recalibration procedure, sounds like the ultrasonic sensors should just be a remove and replace.

I have a '22 R1T. Can't take any new pictures right now as the sensor is currently installed and there's not really anything to show without opening it back up. I'll attach an old photo from before I replaced the applique and cleaned it up. From another post on here (I think from you actually)...

I've seen threads and replies of people talking about replacing these parts and identifying part numbers. However, there are no posts about successful replacements and normal operation afterward. I have a broken parking sensor with cut, sliced harness wires. I bought a new sensor and spliced...