Recent content by spamurai

Overland Ruff Rax, awesome build quality and I really enjoy it. Be sure to get the gap filler molding for the front bottom edge, really cuts down on the wind noise, barely notice its there below 75 MPh.

I have a MyQ garage and a separate gate with a different MyQ remote. Garage worked fine on the R1T, couldn’t get the gate to work for a long time, something got resolved after the last update. I just tried adding after each software update, til it worked.

Adding additional photos of cable routing and the final install. Used a midland NMO base with a removable UHF connector to feed the cable through, the plastic trim over the tonneau shelf has a small gap between sections, I drilled it out slightly to pass the cable through but otherwise the...

I installed a GMRS and a 2M/440 rig with dedicated antennas for each. I experimented with locations and landed on both radios mounted to a wood board with sides in the gear tunnel. Mine is a R1T without the power tonneau. There is a small 3/4 inch pass through between the gear tunnel and the...

Thank you for this excellent review. I have one of these on order now, I was waiting with excitement for the Rivian OEM cover, until reports of the plastic bits breaking off started. My temporary 1/2 plywood cover kinda sorta works but looks like c&$@.

Probably barely counts, offroad training at Hollister Hills SVRA.

I'm actually curious about how to mount anything to the front /grille area and not interfere with the Driver+ features. According to this page https://rivian.com/support/article/what-hardware-is-included-in-rivian-driver there is a forward faciing radar.

Order #31xx, not heard anything yet.

Yesterday I did an 800 mile drive to help family move. Both ways, heavy use of driver+, really helps reduce fatigue. Had the usual sudden disconnects "this section of road is unavailable", but then one complete moment of weirdness that quickly recovered. Was in driver+, it dropped out...

I used Cal Auto Tint in Campbell CA, they rock. ( calautotint.com ). Did PPF on the front surfaces and hood, ceramic coating on the remainder, a dark tint on the sunroof and street legal light tint on the driver/front passenger.

With the Brainexploder dual stripe graphics. I've added PPF on the front and hood, paint protection coating on the rest and extra tint on the sunroof. OEM crossbars not pictured. Came with the tonneau rails and I added a homegrown wood bed cover while waiting for more options. While I love...

Had this same issue, put in a ticket in mid-February for a end-of-march service appointment. Tried a new battery, did a software update while waiting. Long story short, at my service appointment they said the keyfob had a digit transposed @ purchase, did a back-end fix and the setup prompt...