Recent content by Tommy

Same.

This exactly. I have the same need for a truck for hauling stuff and occasional yard projects. At the time, I had a 1997 F150 which fullfilled that roll. It was also my daily driver that I used to commute to work. But I really wanted something more sporty for fun. Of course I couldn't give up...

Yes. Likely an April Fools joke. Check the date OP posted. Ha!

Honestly, it's hard to remember since I've had it at the service center several times over as many months. Once a month on average for a variety of "early adoption" issues. Thus far I am undeterred, but it's beginning to get a bit tedious. My recollection is that it was due to a low voltage...

Yes, this is true. I am hoping that it can be recalibrated in a future software update. I have compared the difference between the R1T and my Raptor and RX350. R1 is consistently 5 to 8 degrees F higher than the others (which are usually both the same). Not a big deal, but definitely not an...

Other forum strings have surmised that 39.3 was pushed to resolve various issues broken by 39.1. Unsubstantiated. Others have stated that if "it ain't broken" you will not receive the 39.3 update. ?‍♂️

Second update of 39.3 complete. Alas, no change. On-board compressor still bricked.

Yes, same here. Updating (again) now. FWIW, 39.3 was supposed to fix the bricking of the compressor which occurred after 39.1. It did not (for me) fix this. Perhaps a reloading of 39.3 is intended to resolve this (?). Will advise.

Thanks for the reply. Ticket filed last week. Service visit skd in 2 weeks.

As far as I can tell, the release notes for 39.03 are exactly the same as the release notes for 39.01. Which is strange and why I thought 39.03 only added the Halloween mode. Anyone with 39.3 see any differences in the release notes?

Yes, it has happened occasionally after sitting unused for a day or two. I've never measured it, but would guess it's only an inch or less and uniformly on both sides. Not lopsided. I've attributed this to a slow leak or perhaps a change in ambient air pressure (?). Not sure, but it's not...

Yup, that makes sense. Thanks for clearing that up! Now, to figure out what changed with the 39.3 update.

No kidding? Orange lights and spooky sounds too? I could be mistaken but I don't think that stuff showed up until 39.3. In fact, those are the only differences from 39.1 that I could find.

I had my R1T in for service earlier this month and they offered to update the firmware on the keyfob while they were fixing the other stuff. After the fob firmware update the R1T now wakes up when I approach the vehicle with the fob (lights blink, suspension pressurizes).

Same here. Also key band no longer works. Not sure how long this has been going on. Sending R1T to the service center Nov 10 for this plus other issues.