Search results

I just looked back at my order history. I ordered on Dec 26th and received the items on Jan 5th. So it did take a couple of weeks to arrive. I also do recall not really getting much in terms of intermediate communication from them. Definitely not a scam website though. They did partner with...

Maybe its because I'm still getting used to it (<2K miles) but I'd love for them to vary the volume of the turn signal by speed. I cant tell you how many times I end up taking a "left around the world" only noticing a mile later that my directional is still on when highway driving. Its just too...

I only have about 1700 miles on my R1T but driving last week for about a 45 minute highway drive I did have the system spontaneously reboot on me. I had nav and spotify active at the time. Its only happened once on me so far though.

I measured from the top of one of the bed "ridges" to the vinyl and its 19.5". To the underside of the tonneau metal bars is 18.5" if you have something that cant fit between the bars. This is the Loredo version though which is lower profile than their standard. They also have lower profile...

Thanks. I think it really adds to the look as well as being much needed. My bad for not understanding your concerns iansriv. I measured the distance from the bottom of the bracket to the ground with the truck in rock crawl mode at highest height. It was 12 inches. Which I guess could be an issue...

Here are some profile pics. I don’t think they do justice to the spacing though. The boards are not really flush with the tires as they are about 1.5 inches or so proud of the tire face. But they are definitely inset from the rear view mirrors if walls are a concern.

Sure. I'll take some pics tomorrow when the daylight comes back. There are some pics of my install a bit earlier in this thread but prolly dont do the spacing justice and they are at night.

I hear that. I found with these mounted as flush as I could get them I didnt have as much room on the board for my boots as I would like so I mounted them further away. Flush absolutely did look better and likely minimally impactful to drag coefficient. Also, my wife was starting to get pissed...

Haha. Trust me, I had thought of that. But I would be lying if I said I didn't have to take the Dremel to widen the slots while they were on the truck to align better because I'm a hack. :) Also with the slots on the brackets and the mounting brackets on the boards themselves they can be...

At first I did not as it was gonna be a pain and I was hesitant about cutting the panels. All the noise of rocks hitting the exposed underside and the salt and sand in New England convinced me otherwise so I took a crack at it last weekend. It’s not the cleanest install but here are some pics...

They do indeed fit the R1t. I just installed them last week. Definitely had to swap the brackets around as others have noted. Also, with the right combination of swapping I ended up using only the 17mm and TP55s. The original instructions calls out using the 15mm with the TP55 for the front...

Hey All. My first post so be gentle. I just picked up an Access Loredo rollup tonneau cover for my 2 week old R1T. I've had one on my Tacoma for 17 years and its held up great. I took advantage of a rare 50 degree day here in Boston to install it this morning. It took about 45 minutes and I...

Added as well (still have a smile stuck on my face).