Search results

No worries about thunder. Whatever get the bike to and from the trails is great.

I am but not sure when, I am testing different materials. I will pick it back up after winter, in the spring.

The flow rate is slow, it would work better with a small air tank to fill from the R1T compressor and then to the bike tire.

I have a similar issue. This is after 11,900 miles (approximately 6,000 in Conserve mode). Rivian replaced the two front tires, with no explanation of the cause. Picts are of front and back tire comparison.

This is a large size 29'er

I am testing out some options for transporting bikes. This one is the 1Up. I am concerned about the negative effect on range. Also when adjusted to fit a large size 29" the rack extends past the lift gate. So far it fits all bikes I have tested. I also am testing the Yakima GateKeeper Medium...

I think this is it

Thanks, I am already testing out a sytem that will accommodate different sizes. Though I have tested a few smaller downtubes and it still works well, so bigger may just work. Thanks for your thoughts I will check that out as well.

I have made them for an F-150 in the past. It’s custom and can be made for any truck. I will let you know if I end up producing it.

When I make the next prototype I will make it bigger and see how it works on smaller sizes. Thanks

I did. This one fits a downtube up to 3.25” wide.

Testing out a prototype custom tail gate bike pad. Protects truck, bike and stanchion. Bike fits great with room to spare. 29’er, gravel, road, all good. Minimal sensor interference. .

rivian.fun