2020
Well-Known Member
- Thread starter
- #1
Needed to pass some wires from the bumper to the inside of the frunk. Removal is pretty straightforward.
-Remove the four plastic covers surrounding the frunk. The front piece is magnetic and the others have simple clips, just gently nudge them upwards and they release pretty easily.
-Remove the 6 screws (circled red). 2 up front, 2 in the rear, and one on each side.
-Unclip the two plugs on each side (circled red)
-Lift out the tub and enjoy the brilliant engineering
-Remove the four plastic covers surrounding the frunk. The front piece is magnetic and the others have simple clips, just gently nudge them upwards and they release pretty easily.
-Remove the 6 screws (circled red). 2 up front, 2 in the rear, and one on each side.
-Unclip the two plugs on each side (circled red)
-Lift out the tub and enjoy the brilliant engineering
Sponsored