Center Console Tray

[Mark_AZR1T]

Large update:

The first 'production intent' version of the sliding center console tray is complete. Please disregard the poor quality of the print - I was focusing more on speed than quality with this one. Here is what we have:

The hanging bit is complete at this point. It's structural enough to hold the basket and a few pounds of equipment, yet flexible enough to deform slightly for installation. Pictured top, bottom and beveled edge that the basket hangs in.

The basket is also functionally complete. the hole grid at the side has come out well from look, light distribution, and overall structural stability perspectives. I think the sizing a little larger than what I initially envisioned, but overall pretty great. The width of the basket is basically as wide as it can get to comfortably drop between the center console wings.

From an installation perspective, it take a whopping 30 seconds to install. Place the hanger in and twist gently. It's designed to give slightly - the picture is somewhat exaggerated for effect. ?

Drop in the basket, seat it in the hanger, and then load it up. Slide back and forth as needed.

I think I'm going to print an additional version in black. I might also make a small run of these for folks who are interested. If you're interested in one, please post here. The estimate for a small batch would probably be in the $30 range.

Outstanding!! I have a similar wallet, but what are the dimensions of the wallet area, so I confirm fitment? Thank you for this! It reminds me of the Tundra slider / tray configuration.

Sponsored

 

[Gimmeoneofeach]

I'd be interesting in purchasing as well. I'd prefer black so dirt would not show. Good work!

 

[cjbot3000]

I would also be interested in black!

 

[RWerksman]

Outstanding!! I have a similar wallet, but what are the dimensions of the wallet area, so I confirm fitment? Thank you for this! It reminds me of the Tundra slider / tray configuration.

90 wide x 16 deep x 57ish tall. It's a bit wider than a normal credit card so wallets like what is shown can just pop right in.

I'd be interesting in purchasing as well. I'd prefer black so dirt would not show. Good work!

Thank you, my dude!

 

[Mark_AZR1T]

90 wide x 16 deep x 57ish tall. It's a bit wider than a normal credit card so wallets like what is shown can just pop right in.


Thank you, my dude!

Thank you. I am in, Black as well....although I'd do a black trim and a Rivian Yellow basket

 

[travbz814]

Definitely interested

 

[waitingforrivian]

I’m interested as well.
I assume this will arrive well before my R1S with estimated delivery of Oct-Dec.

 

[TeamPJ]

I'm interested.

 

[RWerksman]

I've placed an initial order for these. They are expected toward the end of the month. They will be produced in black only at this point. I'll post pictures of the real product when I get them.

I'm a bit concerned about how the grid will look on the batch produced models, but my contact says they'll look pretty good, so I'm hopeful.

Pricing will be around $25.

 

[JoeN]

Good job! I would be interested. Thanks Joe

 

[Mark’s RT-1]

Interested as well.

 

[camaroz1985]

Will also be placing an order for the tray and divider when available.

 

[bdavis171]

Would love to get a black one!

 

[kewlasu]

Count me in on this

 

[Benallen45]

I'm interested in black as well

Sponsored