Search results

Probably drunk or high

OK got it. Thanks. Seems like that should work.

So let me see if I can understand this. You’re planning on only using one 2” angle to mount the sliding rails to the Unistrut? I would imagine you would cut maybe two 1’ sections for each of the slides to mount them to the Unistrut? I would imagine you could also do the same with the 1” angle...

awesome! Glad to hear that.

I think you can. There’s only two clips on the side of the button that you have to push in and then it pulls straight out. Then when you’re done, you just pop it back in.

yes, as long as you keep the parts from the inside of the button that actually toggle the switch part of it. The button just pops apart.

so I pulled off the four small bolts, holding the side, bed panel, and the bolts that you have to access from the tailgate. I loosened the back bolt, holding the tiedown strap. I didn’t want to remove it because I didn’t want it to fall down inside the truck. I then was able to pull the panel...

I love and really appreciate this post. I already ordered the slides and am making a hardware sore run soon to make the “gear tunnel shuttle” only at this point. I do have a question: Where do the 8" sections of lower profile Unistrut go? I am assuming the 10” fo on the ends. Do you have...

don’t disconnect it, disable it

The button is not too difficult to disable to prevent this from happening