A little help please. Need a unique measurement

[bronco7777]

I hope everyone had a great weekend.

I was hoping I could get your help with a unique measurement on the front half of the R1S. I'm about to take delivery next week of an R1S and I have a tight space in my garage. Thus, I need to know how many inches does the R1S have (in a straight line) from the tip of the front bumper to where the A pillar meets the start of the roof. Hopefully the visual below helps clarify what I'm looking for. Eventually I will be remodeling my garage to create greater space. But in the interim I'd like to know in advance if I can get away with parking my car under the current garage configuration. This measurement will help me clarify that.

Sponsored

 

[KBabione]

I just went out and measured my R1S - it's 82" exactly from line to line in your drawing. I taped the tape measure at the spot on the door where the window angle is and then took it straight to a piece of PVC pipe that I held perpendicular to the floor. I might be off a little, but it can't be more than 1 inch. You'll need to add another 1.5 inches if you are worried about the tow hooks.

I hope that helps!

 

[bronco7777]

Awesome. That's very helpful. Thank you for taking the time!

 

[KBabione]

There was a thread called It Fits! back in November where people posted how tight their garage was. You might want to check it out for ideas...

I use a motion-sensing laser parking aide to get my R1S in the garage with just enough room to close the door. Needless to say, I make REALLY good use of the frunk!

 

[bronco7777]

There was a thread called It Fits! back in November where people posted how tight their garage was. You might want to check it out for ideas...

I use a motion-sensing laser parking aide to get my R1S in the garage with just enough room to close the door. Needless to say, I make REALLY good use of the frunk!

Thanks, I'll check that out.

Sponsored