Truck raising / lowering on its own

[RollerCoast]

So I’m sitting in a drive-thru as I type this noticing my R1T slowly lowering from “High” and then the compressor kicking on and raising it back up again. It’s seemingly doing this over the course of 5-10min. I never noticed it in “Standard” height; only in “High.” Anyone have any ideas?

Sponsored

 

[sb335xi]

Started noticing this after last month's update (where 'camp mode' was introduced). Truck seems to 'auto-level' if sitting on an uneven surface for a few minutes.

Would love to see confirmation that this is intended behavior - like a full set of release notes for updates..

 

[RollerCoast]

You’re absolutely right!! It was during a time where I was on a hard incline and the right side of the truck was the side doing all the movement. So it was acting almost as though it was trying to auto-level itself.

 

[Yellow Buddy]

Started noticing this after last month's update (where 'camp mode' was introduced). Truck seems to 'auto-level' if sitting on an uneven surface for a few minutes.

Would love to see confirmation that this is intended behavior - like a full set of release notes for updates..

Mine auto levels as well. Parked half on a small curb, lowered the truck to “lowest”. One side lowered. The other side didn’t to keep the truck level. Kind of neat…after I fell out of the truck of course

 

[Prime]

Isn’t this supposed to only occur when camp mode is activated and the auto level is toggled to “on”?

 

[Dark-Fx]

Isn’t this supposed to only occur when camp mode is activated and the auto level is toggled to “on”?

No, it's load leveling. My truck has always done this. Entirely different from trying to achieve actual level. It should really only do it once, unless you have a leak somewhere.

Sponsored