Recent content by sac602

I used extrusion to make a more permenant solution. Dogs back there a lot so a. Flat serface is more useful. Had this installed 2 years now. https://www.rivianforums.com/forum/threads/fridge-slide-for-r1s-cargo-area-install-could-maybe-work-for-induction-burner-camp-kitchen-too.18935/

Also tighten the wires leaving the breaker. The high voltage repeatedly cycling can cause a tiny bit of expansion that eventually loosens the connection. Happened to me after a few months. Obviously turn off main before tightening. 20-23 ft-lb torque. Once retorqued, I have not had any repeated...

I don't rember the size, but yes, just step it up until it fits.

I used a step drill like this... Titanium Coated HSS Step Drill Bit – 10 Sizes (1/4" to 1-3/8") | High-Speed Steel Unibit for Metal & Plastic Sheet Drilling https://a.co/d/0inRYhOi

I have these too (or ones very similar). Work fine. They do save stuff from falling into the abyss of no return.

I don't see why your setup would not work. That is wierd.

For me once it switched from the free to paid it stopped working (for exam Spotify would no longer work). A mobile service was unable to fix it. They did a soft and hard reset, then disconnected 12v battery. Since they could not fix it, it was elevated to the software team. The next day it was...

Also, turn off breaker and tighten all the wires in the breaker box and going into charger. Mine loosened up. Electrician said the large spike in voltage causes expansiin/contraction and can case wires to loosen. Mine would error (no Arcing) but tightening fixed the issue.

Replace. They are not that expensive. Better to sell your old ones as a set with them in (or have a snow tire set). BTW they are about $50 on Amazon.

Either both sides are freezer, if using dual zone, only the small side is a freezer. You can't have just just the large side a freezer and smaller fridge (unless they changed it in the last 2 years). Also, you can go to camping mode and turn on outlets (there is a timer).

https://a.co/d/6CuxPDJ

34.5 in standard height. I agree steps are the way to go. We got these off Amazon and really like them https://a.co/d/iuLErGs I back into spots with curb, which is high enough for our 70 lb German Shepherd to jump in. Without curb she makes me lift her unless we have the steps.

I run 59. Still a 10% efficiency hit, but worth it for all season traction / flat protection of the E load. Still 10 is a hit

Watching...

More from my chatgpt rabbithole.. 🛡️ What “V‑XI” Means V: Indicates low light transmittance tinted glass (less than about 70% visible light) . XI: Means it’s laminated glass (rather than tempered) . So your glass is a tinted, laminated safety glass pane—often used in car side or rear...