Need a couple measurements from a current R2 owner please

[NinjaWrap]

I got lots of measurements when I did my demo drive, but I missed two somehow. Could a current owner help? You'll need a flexible tape measure that can go around the curves. To the nearest inch is fine.

For this green line, I need the curved measurement between the light and the end of the panel.

For the hood, I need the full width up and over the shape of the hood at the widest point. For the length I just need a straight measurement from the point furthest back at the door to the point furthest forward of the nose.

Sponsored

 

[Thebandit]

Out of curiosity, why?

 

[forestwalker]

Its likely obvious to most here, but might want to specify youre looking for this measurement off an R2.

 

[forestwalker]

Out of curiosity, why?

To design a wrap, I'd imagine.

 

[Thebandit]

Its likely obvious to most here, but might want to specify youre looking for this measurement off an R2.

Bro. It's in the R2 forum. The pictures are of an R2. And the title says R2.

 

[forestwalker]

Bro. It's in the R2 forum. The pictures are of an R2. And the title says R2.

Unless this coffee hasnt kicked in, it didn't previously. Totally a possibility!

 

[NinjaWrap]

To design a wrap, I'd imagine.

Yep, still working on my wrap design! Have the overall look done, but need to get all the details worked out in the next couple months

 

[Rizzian]

Mike,
I've got some Wrap question, because I've never had a car wrapped before. I'm looking to do some 80's class-b Rally inspired wide racing stripes on an Esker Silver R2, just utilizing 3 colors. What's the best way to accomplish something like my example (attached)? Would you cut black, white and yellow vinyl sheets, or is it better to print a single 3-color "stripe" as one piece and apply it? Sorry for the noob wrap question, thanks. Not looking to wrap windows, that's just sloppy AI.

BTW, sorry I don't have my R2 yet so I can't help with dimensions. I'm just reacting to an R2 Order list where everyone seems to be ordering Catalina Cove and Launch Green R2's for a $2k premium. I hoped I could take the base color (Silver) and spend some money on a wrap to set it apart.

 

[NinjaWrap]

Mike,
I've got some Wrap question, because I've never had a car wrapped before. I'm looking to do some 80's class-b Rally inspired wide racing stripes on an Esker Silver R2, just utilizing 3 colors. What's the best way to accomplish something like my example (attached)? Would you cut black, white and yellow vinyl sheets, or is it better to print a single 3-color "stripe" as one piece and apply it? Sorry for the noob wrap question, thanks. Not looking to wrap windows, that's just sloppy AI.

BTW, sorry I don't have my R2 yet so I can't help with dimensions. I'm just reacting to an R2 Order list where everyone seems to be ordering Catalina Cove and Launch Green R2's for a $2k premium. I hoped I could take the base color (Silver) and spend some money on a wrap to set it apart.

Personally I’d do that as a print that is contour cut to the shape. Otherwise do it in layers but still contour cut on a plotter from solid vinyl colors. By the time you get enough material for three layers it may end up costing about the same either way.

Sponsored