Search results

I disabled/re-enabled the integration and it started working again... not sure what happened.... ?‍♂️

I finally found where my rattle is coming from! Above about 55 mph I am getting a pretty horrible rattle, sounds like trim is fluttering in the breeze from the 2nd row passenger side. I taped up the trim piece between the roof rack cleats with painters tape and the rattle stopped. It feels...

I would be surprised if a little rubbing alcohol or ammonia based windex wouldn’t remove it. What have you tried? Edit: here is the first ingredient… ——————— Sodium metasilicate is the chemical substance with formula Na2SiO3, which is the main component of commercial sodium silicate solutions...

The 2024.03.02 software update seems to have broken my unofficial rivian integration in Home Assistant. It is not updating values anymore. has anyone else had issues?

you are correct. It was a test and you passed. (slowly backs out of the room…)

What grade of stainless is it?

I’m confused… do you just have one tire with low pressure? Are you using a separate gauge to fill your tires to the same pressure, but the TPMS is reporting different pressures on the display? what is the actual issue?

I have noticed that when the motors are in battery warming mode they can can be pretty far off from eachother. why is your battery temp not shown?

If one wheel was spinning slower than the rest it would be obvious and the tread would be gone in a few miles. my motors read different temps regularly, how far off are they?

maybe, but this isn’t that. It is actually charging:

Nothing that registered on my UPS…

Well I got a stopped charging error sometime last night. No apparent reason for it…. I have gotten this before too. Anyone else experience this or do I need to get an appt? Until this error it’s been plugged in for about 5 days straight without issue. Got up to 73.2 % max charge.

I have observed this before but only 1/2 or 1 % over because like you I don’t leave it plugged in for long periods like this normally. SOC “limit” seems to be more of a suggestion. now I want to leave it plugged in for another week to see what happens.

I usually plug in over night in my garage (rivian charger) and wake up to 70% charge which is my limit. My daughter has been in the hospital all week so I haven’t unplugged the rivian since Monday evening. I just checked and my SOC is at 73% which seems like quite a bit over the 70% set point...

https://dirtyhookerdiesel.com/i-24077904-dhd-600-625-rivian-r1t-r1s-steel-tie-rod-sleeves.html has anybody tried this (or something like it)? what is the next part that would break of the tie rod was stronger?

nevermind upon closer inspection there appears to be some kind of shuttle attached to the front wheel. I was hoping for a 7000 lb 1:1 scale remote control car.

Wait, how did they drive it for this test… wasn’t being towed by a cable… and I doubt they would use a human driver, at least I wouldn’t do it. I want to know what kind of remote control setup they have to accelerate to a set mph and steer accurately.

that’s an interesting method. With just the HA integration with ratgdo I can’t figure out how to block the wall remote… I can only stop the door after it starts, but it’s pretty responsive, so it will probably stop the door in time.

Not to wake a stale thread, but this is awesome. I’m in the middle of switching from smartthings to home assistant. I am going to write a script to keep the garage door from auto-closing if the R1S is at home and the liftgate is open. Got some good scratches on the minivan tailgate from that.