On board compressor doesn’t set

[irvineboy]

I was testing the onboard compressor today and set the PSI to 48. It inflates it past 48 PSI. I thought it would inflate and automatically stop once it reaches the set PSI. On mine, you have to manually press the start/pause button and it will show you what PSI it is at. Is there a way to set it to stop once it hits 48? Or is my onboard compressor faulty?

Sponsored

 

[sub]

Re-read the instructions. If you follow the procedure exactly it will stop at the setpoint but if you skip a step it will keep going.

Also you have to start the whole procedure over for each tire. You can't just move it to the next tire and press go again or it won't stop at the setpoint.

 

[Birdowin]

Thanks for that info. I have found that mine stops before it gets to the set point and then either shuts off or goes in very small increments. I usually end up setting it 10psi over and then stop it when it reaches 48. I will read the owners manual.

 

[R1TCntrlMaIzzy]

If the display does not show "set", the target PSI will not be met, at all.

Yes, there are some compressors that will bot work, but the proper steps need to be followed to have a chance.


https://www.rivianforums.com/forum/threads/air-compressor-doesnt-stop-at-set-psi.36062/#post-659823

Sponsored