Access Loredo Tonneau Cover installed

[muneebk]

Hey All. My first post so be gentle. I just picked up an Access Loredo rollup tonneau cover for my 2 week old R1T. I've had one on my Tacoma for 17 years and its held up great. I took advantage of a rare 50 degree day here in Boston to install it this morning. It took about 45 minutes and I think it looks great. If anybody is looking for a rollup here is another good option for you (I know there are others, including some site sponsors. I have no affiliations). I took some shots of the bracket heights that kept the rails level for me and a little hack I did to try and help it be as water resistant as possible.

I really love this truck. Like, maybe too much.

Added a little piece of the rubber gasket to each of these "tracks" to help keep water out:

Here is a pic of the bracket heights that kept the rails most parallel:

With it rolled up:

Sponsored

 

[corndog]

Very clean looking. Nice install. Thanks for the pics!

 

[Hexijen]

Hey All. My first post so be gentle. I just picked up an Access Loredo rollup tonneau cover for my 2 week old R1T.

I'm thinking about getting the access cover and I was wondering if you know the clearance under the cover, measured from the floor of the bed to the underside of the cover at its highest point?

 

[muneebk]

I'm thinking about getting the access cover and I was wondering if you know the clearance under the cover, measured from the floor of the bed to the underside of the cover at its highest point?

I measured from the top of one of the bed "ridges" to the vinyl and its 19.5". To the underside of the tonneau metal bars is 18.5" if you have something that cant fit between the bars.

This is the Loredo version though which is lower profile than their standard. They also have lower profile versions as well.
I hope this is helpful.

 

[Hexijen]

I measured from the top of one of the bed "ridges" to the vinyl and its 19.5". To the underside of the tonneau metal bars is 18.5" if you have something that cant fit between the bars.

This is the Loredo version though which is lower profile than their standard. They also have lower profile versions as well.
I hope this is helpful.

That is helpful, my preferred fridge is 18.1 inches, and the ridges of the rivian bed are 3/8, so i think this thing will juuuuust barely fit. I'm going to investigate the higher profile versions to see if i can get a bit of breathing room.

Thank you for your help!

Sponsored