Window will not calibrate in up position.

[BCan]

My right rear window will not calibrate in the up position. My other 3 windows calibrate as they should, up & down position, per the service manual.

when my problem window is auto’d up, it goes into the seal normally, then goes down 4ish inches. I don’t get the main screen indication it calibrates in the up position. Tried vehicle reset. Mobile service scheduled…

anyone?

Sponsored

 

[BobinIndy]

Had the exact same issue… mobile service did a 5 minute calibration and all was good after.

 

[Oldsmobile_Mike]

There's a few threads on this forum and on Reddit that describe window calibration procedures. Worth a shot?

 

[SteveInBend]

Same thing happened to me with front passenger window. Ran through the calibration process decribed in the owner's maunal, did a soft reset, called support and did a hard reset. To no avail. Scheduled an appointment with mobile service. Got it fixed in 5 minutes.

 

[BCan]

There's a few threads on this forum and on Reddit that describe window calibration procedures. Worth a shot?

I can do the calibration on the other 3 windows…i have one window that doesn’t recognize the up calibration.

 

[BCan]

Same thing happened to me with front passenger window. Ran through the calibration process decribed in the owner's maunal, did a soft reset, called support and did a hard reset. To no avail. Scheduled an appointment with mobile service. Got it fixed in 5 minutes.

Did they give a cause?

 

[SteveInBend]

Not really. Just said it needed to be recalibrated and had to plug their laptop into the port and use their software to do it.

 

[sccmexpert]

Had the exact same issue… mobile service did a 5 minute calibration and all was good after.

Ditto here. Driver side window had the issue. Mobile service came to the house, fixed and was gone in 5 minutes.

Sponsored