solaskaze
Well-Known Member
- Thread starter
- #1
First world problems, I know, but: anyone out there have a solution, or a 3D print for a oval "L" bracket to fit over the charge port light (to shine it into the actual port).
The idea is that one applies mirrored film on the inside, to shine the light on the actual port, instead of directly into one's eyes. The color would still be easily visible.
Is there enough of a gap there between the inner door assembly (inside the seal) ?
The ring is so bright, in the dark the glare makes the actual port completely invisible unless combatted with pulling out the torch.
The idea is that one applies mirrored film on the inside, to shine the light on the actual port, instead of directly into one's eyes. The color would still be easily visible.
Is there enough of a gap there between the inner door assembly (inside the seal) ?
The ring is so bright, in the dark the glare makes the actual port completely invisible unless combatted with pulling out the torch.
Sponsored